Post 1 made on Sunday January 13, 2008 at 13:06 |
LNBF Lurking Member |
Joined: Posts: | December 2007 9 |
|
|
Hey all, I am setting up a Pioneer VSX81 and I am a bit confused about the RS232 controls of zone 2. I have been to Pioneers website, and have the list of commands for the receiver, but it does not seem to have direct commands of zone 2 other then on, off, vol up and dn. Unless I am not understanding it correctly. It does list a "function mode set" but nothing for like zone 2 dvr1, again I might be misunderstanding the codes. If anyone can help, it would be appreciated.
Thanks Dave
|
Custom Coach Installer RTI Dealer/Installer; Datastorm Certified Mobile Satellite Guru |
|
Post 2 made on Sunday January 13, 2008 at 17:57 |
NSP01 Advanced Member |
Joined: Posts: | March 2005 834 |
|
|
Zone 2 Function Mode Set is XXZS. XX = the function number that is the same as the Zone1/Main Room function numbers further down the page. 01ZS is CD for Zone 2, 02ZS is Tuner for Zone 2, and so on. Don't forget that all functions are not available in Zone 2. Good luck!
|
They call me the "Thread Killer". Just watch! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.