Post 1 made on Wednesday December 20, 2000 at 00:20 |
Jose Valls Historic Forum Post |
|
|
I have been copying Hex codes from Pronto edit to T2 without any problem. I need codes for a particular equipment and I found the CCF file, however when I open the device I can not see the Hex code. I think is using an Alias from Pronto edit. I am not very familiar with Pronto Edit, Could somebody help me if is there any way I can copy and paste Hex codes when they use an Alias in Pronto edit?
Thanks Jose
|
|
OP | Post 2 made on Wednesday December 20, 2000 at 15:53 |
Anthony Historic Forum Post |
|
|
If it is an alias, then it will tell you where, VCR - Page1 - Play: Device or macrogroup named VCR, then go to panel Page1 and button Play. TV - Vol+ : Device or macrogroup named TV, click on system properties and then vol+
|
|
Post 3 made on Saturday June 22, 2002 at 21:16 |
JOSE, Can you help me. RTI does not have the discrete on-off codes for a Toshiba TV 36AX60. I am told the Pronto does have these codes. I do not have the Pronto, only the RTI T2. If this is correct, can you email me the codes? [email protected]
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.