On December 11, 2007 at 23:13, Glackowitz said...
On the samsungs I have found that if you are using HDMI
even with a discrete code it wont go to that input unless
a source is connected and on, we had an issue with a DVD
player, had to power on the DVD player first and get it
playing then power on TV and select input then it was
ok, if tv wasnt ready or DVD wasnt playing it always defaulted
to last input
Had us confused at first until we saw what it was doing.
then reworked a few macros to correct the issue
Thanks for the tip. Now that you mentioned this I remembered this behavior when we first hooked the set up. Saved me some troubleshooting time.
For the DLP TV's, what do you do to control it. i.e. do you use an emitter or just send the IR codes from the remote? If you do use an IR sensor, where do you put it? Thanks
TGRUGETT,
I have downloaded those codes and some other I have found and will try them all.