| Post 1 made on Sunday December 9, 2007 at 11:57 |
Bauer83 Long Time Member |
Joined:
Posts: | September 2007
33 |
|
|
Is the only way that you can get page links on scrolling lists by putting the entire remote in standalone mode? It seems that this is the only way, which means a lot of added work for me when it comes to changing my remote over from RF trigger codes.
Is there anyway to select all the buttons on the page, and change them over to RF?
|
|
| Post 2 made on Sunday December 9, 2007 at 14:54 |
Springs Super Member |
Joined:
Posts: | May 2002
3,238 |
|
|
Laso the buttons...
Right Click
Drop to properties
Second tab
(Output)
Select RF trigger codes
Provided it has a system controller somewhere in the file.
As for scrolling lists... don't use them so I am not sure on the page link thing.
|
|
| Post 3 made on Sunday December 9, 2007 at 15:27 |
cheesehead22 Long Time Member |
|
|
Conrtol A...selects all buttons
Hover above a selected butoon and right click to access the proerties of all the buttons selected.
This is how I modify the text(or anything else for that matter) on an entire page of buttons.
|
Don't read my answer. Someone else will go into great detail as to why I am wrong rather than answer the original question... |
|
| OP | Post 4 made on Sunday December 9, 2007 at 15:41 |
Bauer83 Long Time Member |
Joined:
Posts: | September 2007
33 |
|
|
I was not clicking on a button when I right clicked, that solved the problem. Thanks!
|
|
| Post 5 made on Friday December 14, 2007 at 21:19 |
Homesurround Lurking Member |
Joined:
Posts: | December 2007
9 |
|
|
So did anyone figure out the procedure to do a page flip from the scrolling list object? Thanks...
|
|
|
| OP | Post 6 made on Saturday December 15, 2007 at 12:17 |
Bauer83 Long Time Member |
Joined:
Posts: | September 2007
33 |
|
|
By page flip, do you mean page links in macros? If so yes, it is solved by change the entire device properties to Standalone mode. A word of caution, if you then want to run macros on the RP6, you seem to have to right click on the system macro in the actual macro and change the default mode to RF. This took a lot of time to troubleshoot, but appeared to be my problem.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
