|
|
|
RTI Control Systems Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
T4 converted to K4, K4 has problems
| |
|
Topic: | T4 converted to K4, K4 has problems This thread has 4 replies. Displaying all posts. |
|
Post 1 made on Thursday October 18, 2007 at 08:42 |
mncsolutions Long Time Member |
Joined: Posts: | March 2007 48 |
|
|
I have a T4, K4, RP-6, CB-4, and an RM-433. I converted the T4 to K4. The T4 works fine but the K4 works then if you do something on the T4 the K4 stops functioning and I need to reset the RP-6. The RP-6 has the latest firmware. The CB-4 is connected to the RP-6 through the Patch cord. The RM-433 is connected to the RP-6. I have also tried to change the freq. for the K4 and still had the same problem.
|
Matthew Chartier MNC Solutions |
|
Post 2 made on Thursday October 18, 2007 at 10:14 |
markrubin Founding Member |
Joined: Posts: | February 2002 919 |
|
|
you mean you converted the T4 to a K4 in the program?
One thing to try is turn the IR sensor off on the K4 if you don't use it: that has always been a problem with any of my RTI TP's
|
|
Post 3 made on Thursday October 18, 2007 at 14:40 |
TOOOLDAND TOOGRUMPY Long Time Member |
Joined: Posts: | October 2007 351 |
|
|
check the firmware in both the T4 & K4 also, if you have not already,latest is V1.3. we had some K4 with issues immediately apparent. latest firmware - sorted
|
|
Post 4 made on Friday October 19, 2007 at 08:59 |
estech Active Member |
Joined: Posts: | August 2002 584 |
|
|
Did you make a copy of the T4 before converting it, so you have both devices in your system file? Even though their status is "Up to date", try downloading programming to everything again. My guess is the RP-6 stops responding to commands from the K4 after the T4 sends out a command because of some kind of conflict.
|
Pay no attention to that man behind the curtain. |
|
OP | Post 5 made on Friday October 19, 2007 at 14:38 |
mncsolutions Long Time Member |
Joined: Posts: | March 2007 48 |
|
|
Found out what the problem was even though the device default was IR Trigger Codes for Control System and the buttons were set for the device default it was not triggering off any system macros. Had to set them from device default to IR Trigger for Control System.
|
Matthew Chartier MNC Solutions |
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|