Under the scrolling list properties (T2C) there doesn't seem to be a way to change IR routing for the whole scrolling list. Am I missing it or does this just not exist?

what do you mean by changing the IR routing??

did you move the device to a different IR port??

are you trying to use 2 devices for the scrolling list??

did you change devices?? If you changed devices do a IR code search and replace

You can definately change the IR routing for the entire list.

OK. How? The only way that I can see is to go in and change the IR routing for each individual command in the macro. Is there a way to do it for the whole scrolling list at one time?

Glack, in reference to your question I am doing this for identical scrolling lists for two cable boxes on the same remote.

There is no way that I know of to change the IR routing properties of the list globally. I asked this question a few months ago. I was doing each command separately to change the routing. But if you use the disc macro wizard it will take just a few seconds to redo the whole list with new routing, at least for my purposes. (DMX favorites) Works like a charm for me.

The same problem exists for macros in general. You can set the IR routing using the wizard but you can not select a macro, a group of macros, multiple commands within a macro etc... to change the IR routing. This would be very useful for scenarios with multiple like devices especially with channel macros.

It would be very cool to select device codes by the page or on multiple pages and change the routing regarless if they are single commands on a button or within macros. It could similar to the IR code search and replace feature OR the IR code search and replace feature could be modified to include IR routing and and have the option to apply globally (as is currently does) or locally (to particular pages).

If I'm reading this thread right I haven't had this problem. As long as the scrolling list is in RF or IR Trigger modes as opposed to standalone you can change or route the IR outputs.

The question is to be able to change the routing without having to do it command by command in each macro.

Try changing the scrolling list to RF trigger codes under its properties just like you would a button and run the macro wizard, I just made a quick test T2C just to make sure and it looks like it's routed to output 2 as requested. Even looked at the Macro's individual commands.