Post 1 made on Thursday November 2, 2000 at 00:53 |
All of a sudden today, my IR543 no longer accepts commands from my T2 in a reliable manner, neither via direct IR nor via the IRF-6 with emitter.
I tried changing repetitions (0-2) and frequencies (between 38.5 and 41 kHz, what is the correct frequency anyway?) for my X-10 commands, but no difference.
My IR543 works fine with the IBM Home Director remote (RS 15-1924). But when I use the buttons on the IR543 directly, it often gets confused (sending a command to multiple addresses etc.)
What the freak is going on?
|
|
OP | Post 2 made on Thursday November 2, 2000 at 20:43 |
Get an Ocelot and all your problems will be gone, I did and I am very happy with it.
|
|
OP | Post 3 made on Thursday November 2, 2000 at 21:42 |
Frenchie Historic Forum Post |
|
|
I am Sorry. BUT, what the freak is a OCELOT?
|
|
OP | Post 4 made on Thursday November 2, 2000 at 22:55 |
Bill E Historic Forum Post |
|
|
Applied Digital product, converts IR to X10 runs macros has built in clock to execute commands at various times and is programable (software could be better). I use one in my house for timed lighting it does its job well. Bill www.homeautomationnet.com
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.