Post 1 made on Tuesday August 28, 2007 at 14:58 |
oex Super Member |
Joined: Posts: | April 2004 4,177 |
|
|
macros are very irratic. connecting ir from connecting block into mrf350. have identical system on first floor. works flawless. wire in wall is the culprit. im using cat5 and ive tried:
different pairs for 16v, gnd, data no shorts in any pairs - verified used all whites as ground keypad from 1st floor to test remainder of system used short piece of wire not inwall and all works perfect. going to try 2 prs to signal use whites as drain increase repeats
|
Diplomacy is the art of saying hire a pro without actually saying hire a pro |
|
Post 2 made on Tuesday August 28, 2007 at 18:05 |
Are you getting a true 16V (+/- 1 volt) at the KP location? Have you tried the operational K3's power supply on the erratic one?
Have you looked for anything that may be inducing IR noise on the line? Sunlight, LCD TV etc? Maybe try covering the IR receiver on the KP and see if that helps.
Bad 350?
|
|
OP | Post 3 made on Wednesday August 29, 2007 at 15:16 |
oex Super Member |
Joined: Posts: | April 2004 4,177 |
|
|
update. Wire pinched under metal ductwork in severla spots. run long distances w/AC
able to rewire the first 40' of wire and the last 30' of wire leaving existing 15 in the middle. all is well
|
Diplomacy is the art of saying hire a pro without actually saying hire a pro |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.