Post 1 made on Tuesday July 31, 2007 at 13:20 |
reclipse Long Time Member |
Joined: Posts: | December 2006 216 |
|
|
I have a job spanning 3 floors and a lot of metal support structure. How many RM-433 RF thingies can I run off one RP-6? Plus, RTIs cut sheet said I can use IR connection blocks to pass the signal thru (as a booster I suppose). Can the block provide power to the RM-433s? I have 4 RM-433s that'll need to go in for the coverage i need (big) and possibly boost the singnal from 1 or 2 of them, I know at least one will just wire straight to the RP-6. Any suggestions, wire diagrams is welcome. Thanks.
|
Joe C the Cable Guy |
|
OP | Post 2 made on Tuesday July 31, 2007 at 13:22 |
reclipse Long Time Member |
Joined: Posts: | December 2006 216 |
|
|
Ignore this thread. I found the answer. Sorry.
|
Joe C the Cable Guy |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.