Post 1 made on Tuesday July 17, 2007 at 23:18 |
tgrugett Select Member |
Joined: Posts: | August 2004 1,850 |
|
|
I implemented a Rotel RX1052 four zone receiver today and had to overcome a couple of issues.
1) Do not follow the 232 pin out information in the manual. It is wrong. Use the DB9 to RJ45 adapter cable diagram that is available as a separate download.
2) When using an RP6 or RP1, ground the processor (via the IR ground on the block) to the receiver at the ground lug to eliminate horrific volume ramping control signal bleed into the audio stream.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.