I am new here so please don't laugh at my dumb questions. Anyone tell me how to get the T3 to send rf and ir ??? I have the RTI RM-433 RF Receiver.

- the RM433 must be connected to the RP-6

-add the RP-6 as a device to the same file as the T3

-set the T3 output properties for the commands you want to be RF to: use device default (RF trigger codes)

these commands will now be sent to the RP-6 (via the RM433) as RF and the RP-6 will send the IR commands from its port (s)

this is the short version!

Thanks Mark. Could you be a bit more specific re this comment:

set the T3 output properties for the commands you want to be RF to: use device default (RF trigger codes)

I see the the output properties window, if I set the default to - RF Trigger Codes - will the T3 send everything in RF only?

as an example:

right click on a button with an IR command to bring up the properties menu: click on the output tab:

now you should see the choice for device default which has to be checked for RF operation

if you don't see this choice, check that the RP-6 has been installed as a device in this same file

OK, I get it now. Thanks a million!

Hey Charles. Good to see you over here. I think you will get more from your remote in these forums. More people here use the upscaled remotes and not the Harmony's like on AVS.

Let me know if you still need any help, would be glad to assist you still

Thanks Bruce, I'm learning.

Charles, I sent a reply to your email.

There are alot of good people in here and can offer some good advise when needed

Nice choice on the RP-6 and RM-433