| Post 1 made on Saturday September 17, 2011 at 22:26 |
belowground Long Time Member |
Joined:
Posts: | February 2008
10 |
|
|
My Rotel RSX-1055 will not fully power up. When I turn it on the red power light comes on, I hear a click, but the display never comes on and I get no audio or video. The two fuses inside appear to be fine. The only reset procedure I can find is to select FACTORY DEFAULT in the setup menu. Without the unit powering up, i can't do that. Does anyone know of a hard reset procedure upon power up? Any suggestions on what may be the problem?
Thanks,
Mark
|
|
| Post 2 made on Friday September 23, 2011 at 13:08 |
Ernie Gilman Yes, That Ernie! |
Joined:
Posts: | December 2001
19,735 |
|
|
It's time to look up Rotel on the internet or look up one of their service stations. I consulted the manual and sure enough, that's the only procedure they offer. They sure didn't expect your problem!
|
We can't give you a good answer, or maybe any, without the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw
|
|
| Post 3 made on Saturday January 21, 2012 at 15:36 |
homeplanit Junior Member |
Joined:
Posts: | January 2012
1 |
|
|
I had the same problem recently with my RSX-1055. It would click into "protection" about 2 seconds after turning on via remote or front button. I may have shorted a surround speaker output after rearranging equipment. Fixed now but I haven't picked it up yet - I believe he replaced output power transistors, about $130CDN repair.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
