| Post 1 made on Sunday January 9, 2000 at 17:32 |
I have a thin red line (and I'm not talking about the movie) in the middle of my picture, from the left hand side all the way to the right. It is not a convergence problem, I have checked all that I can. Its a runco 933 with an outboard trippler into an extron RGB switcher. I see the line on every source except the HD signal. Anyone ever seen a horizontal red line from a bad extron swithcher???
|
|
| OP | Post 2 made on Sunday January 9, 2000 at 18:08 |
Ron Davis Historic Forum Post |
|
|
If all of your sources other than HD are routed through the tripler, it's likely your problem. If it's new, Runco will replace it. Disconnect the RGB cables from the switch output and connect them directly to the tripler outs. That will eliminate the switch as being suspect
How do you like your HD? What HD source are you using?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
