I have a dilema. I am running two zones of a Xantech ZPR68 in the same area that shares a common inwall sensor. The only way the ZPR68 distinguishes which zone is being controlled is by which zones IR port is being sent the signal, since all zones have the same commands for volume up and down and so forth. I've heard of devices that will spit out an IR command if you send it a trigger IR command. Wher do I find these, or is there another way to do this?

Thanks
Tim

Hi tim,

If I understand you correctly, I think you could probably use xantech's Ir router and it should solve the problem, it allows you to route ir commands to one specific device in a system where there are multiple devices using the same codes.

anyway, it's just a thought.

thx, PF