Post 1 made on Wednesday December 29, 1999 at 23:18 |
I have a dilema. I am running two zones of a Xantech ZPR68 in the same area that shares a common inwall sensor. The only way the ZPR68 distinguishes which zone is being controlled is by which zones IR port is being sent the signal, since all zones have the same commands for volume up and down and so forth. I've heard of devices that will spit out an IR command if you send it a trigger IR command. Wher do I find these, or is there another way to do this?
Thanks Tim
|
|
OP | Post 2 made on Saturday January 1, 2000 at 22:34 |
The Audio/Video Doctor Historic Forum Post |
|
|
Hi tim,
If I understand you correctly, I think you could probably use xantech's Ir router and it should solve the problem, it allows you to route ir commands to one specific device in a system where there are multiple devices using the same codes.
anyway, it's just a thought.
thx, PF
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.