| Post 1 made on Friday November 20, 1998 at 08:27 |
I have a receiver that has a Power ON button AND a Power OFF button on the remote. Is there a way to program the AV2000 to alternate between signals so that the Power button can alternate between the 2 frequencies?
|
|
| OP | Post 2 made on Friday November 20, 1998 at 16:14 |
Daniel Tonks Historic Forum Post |
|
|
The AV2000 only has a "POWER" button, and there's no way to program two signals to it. However, you could always use one of the macro buttons for System On, and another for System Off. Most receivers with specific ON and OFF buttons also have a standard Toggle button that may not be reproduced on your remote - perhaps this is pre-programmed.
I know this is the case with my Sony GA8ES. To turn the system on, you push a component button, which turns the system on to that component. To turn it off, you press the OFF button. There was no generic ON button. However, the AV2000 came programmed with a toggle button that would simply turn the system on to the last component, and also turn it off.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
