Post 1 made on Thursday January 28, 1999 at 13:35 |
I finally got around to trying some macro programming last night. I made one to switch the TV's (KV27V20) speakers on/off for when the receiver is off/on.
The macro works fine, but during programming, it wouldn't actually send the signal out, like the manual claims, so I had to write down the sequence of buttons to push, then program from that.
Otherwise, I'll say that the AV2000 plays back the macro slowly compared to my Home Producer 8.
|
|
OP | Post 2 made on Thursday January 28, 1999 at 15:21 |
Daniel Tonks Historic Forum Post |
|
|
Kaz: Hmm, I don't believe it send out signals while programming here either. Yes, it is a bit slow sending out macros... but not too bad.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.