Post 1 made on Saturday July 7, 2001 at 03:45 |
J.Hernandez Historic Forum Post |
|
|
Hello, I have a dishnetwork JVC receiver that came with a UHF/IR remote. I needed a remote that would control all my components so I bought the All For One Cinema 7, it controls everything great except my Dishnet. receiver. I have set the receiver to accept I/R and found the code (0775) and set the receiver to address 1 no luck. If any suggestions send e-mail or respond to message thnks.
|
|
OP | Post 2 made on Sunday July 8, 2001 at 11:38 |
If your talking about the original JVC with the built-in DVHS recorder, I recall that the satellite receiver portion was UHF only. The remote is a combo UHF/IR for two reasons. First, it also is a universal remote operating many brands of TVs, VCRs and cable boxes. Secondly, the internal DVHS was IR only.
It has been many years since I have seen one and my memory may be incorrect, but if it is an older one like described you may be out of luck. If it is a newer model that corresponds to a relabeled DISH version, then you should be OK. Try other addresses unless the All for One specifically says the address is "1".
Good luck,
Randy
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.