Hello, I have a dishnetwork JVC receiver that came with a UHF/IR remote. I needed a remote that would control all my components so I bought the All For One Cinema 7, it controls everything great except my Dishnet. receiver. I have set the receiver to accept I/R and found the code (0775) and set the receiver to address 1 no luck. If any suggestions send e-mail or respond to message thnks.

If your talking about the original JVC with the built-in DVHS recorder, I recall that the satellite receiver portion was UHF only. The remote is a combo UHF/IR for two reasons. First, it also is a universal remote operating many brands of TVs, VCRs and cable boxes. Secondly, the internal DVHS was IR only.

It has been many years since I have seen one and my memory may be incorrect, but if it is an older one like described you may be out of luck. If it is a newer model that corresponds to a relabeled DISH version, then you should be OK. Try other addresses unless the All for One specifically says the address is "1".

Good luck,

Randy