| Post 1 made on Sunday May 13, 2001 at 15:02 |
I have X10 controls setup up on ActiveHome on home codes E & F. Last night all the lights and fans on E went on suddenly. I was unable to turn them off by either the console via AC nor the hand held transmitter for about 10 minutes. After about 10 minutes, I was able to turn them off.
Just about 10 minutes ago all the fans & lights on F went and it took about 10 minutes before I could turn them off.
The Active Home controller is connected to my desktop system which is disconnected because I am building a new one and have not conntected to the controller yet.
Could that be the cause of the problems? Very few of the fans and lights on F are set to go on automatically.
Any suggestions?
|
|
| OP | Post 2 made on Monday May 14, 2001 at 08:32 |
Just to get you're attention, you posted in the wrong forum. Might want to repost to get a better response.
|
|
| OP | Post 3 made on Monday May 14, 2001 at 08:33 |
Scratch that, I see that you already did.
My bad...
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
