Post 1 made on Saturday January 22, 2000 at 10:57 |
Eric E Historic Forum Post |
|
|
I've noticed that some codes taught to the Pronto come out several times longer than the cleanly learned ones. Also, when put into IRtool, they're decoded as raw/unknown, whereas the clean codes decode correctly.
Now, when the learned commands don't work properly, I know there's a problem. But when the command does seem to work, despite the long and sloppy learned IR code, should I be concerned? Or should I take an if-it's-broke-don't-fix-it attitude?
Thanks
|
|
OP | Post 2 made on Saturday January 22, 2000 at 10:58 |
Eric E Historic Forum Post |
|
|
Uh, that should be if-it-ain't-broke-don't-fix-it. . .
|
|
OP | Post 3 made on Saturday January 22, 2000 at 11:10 |
Eric E Historic Forum Post |
|
|
Oops again--I'll put this on the main Pronto forum where it belongs.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.