Post 1 made on Thursday June 27, 2002 at 21:14 |
I have a Misubishi HD 400 receiver fed the the digital audio input a B&K ref 30 preamp. When I am watching a HD channel and switch to another HD channel I get a POP noise out of the right speaker only. this happens when the audio is fed through the B&K. When switching from channel to channel in analog there is no pop. Any suggestions what is causing this? thanks
|
|
Post 2 made on Saturday June 29, 2002 at 00:21 |
kabster Founding Member |
Joined: Posts: | July 2001 1,606 |
|
|
sounds like a switching problem maybe their digital feed getting turned on and off when you change, hmmm just the right ? ummm is your sub mono ? and mono out from the p-amp ? (note most not all but most low freq. stereo doesn't matter.) Although we have been getting some great results using two subs in the theater's with different but slightly overlapping slopes.
|
|
Post 3 made on Monday July 1, 2002 at 11:39 |
ECHOSLOB Founding Member |
Joined: Posts: | February 2002 391 |
|
|
HEY DON,
I had a similar situtation except is was on all channels. DTV RCA DTC-100 optical out through a Pioneer 850 receiver. I changed receivers to a Denon 5803 and no more popping. I didn't change receivers because of this. It took a day or so to realize it had gone away because I was so use to it. :)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.