Hello Everyone,

I have a programming question regarding the programability of the SAT-HD100 unit.

The SAT-HD100 has a built-in Tuner for Over-the-Air Channels. When one runs the auto-program for theses channels, It will display channels as follows:

3.0 (ANLG) 3.1 (DGTL) 6.0 (ANLG)

When I surf through the channels, I am shown Channel 3.0 (ANLG), 3.1 (DGTL) 3.2 (DGTL) 6.0 (ANLG) Etc..

Channel 3.1 has the HD signal and shows the channel in the letterbox format. Channel 3.2 is a digital signal but it shows the channel in the standard Full screen format.

I get this for several of the local channels.

My goal is to block out the analog and Digital signals that are not High Definition.

The add/skip function of the SAT-HD100 allows me to skip/block out the analog channels with no problem. I am however unable to selectively block out channel 3.2, If I block out the digital channels, it blocks out Both 3.1 and 3.2.


I am at the point that taking a sledge hammer to the SAT-HD100 is sounding like a very good idea..


Please help.

Thanks, ASESINO

(always check your 6)

your stuck with what you got. The Zenith DTV1080 has the ability to edit the channels the way you want. Its off air performance is second to none.