| Post 1 made on Monday December 31, 2001 at 13:01 |
automation-arts No Longer Registered |
|
|
Anyone know how to erase certain channels in the antennea section so that off air and HDTV off air channels show up smoothly through a channel up and down sequence on the original remote....
I have NBC on 15
I get HDTV NBC on 15-1
I pick up 16 on the channel scan
When I erase 16 I lose 15-1......
I dont want the filler channels that dont receive anything when I channel up and down.....
Any ideas...
Mat
|
|
| Post 2 made on Monday December 31, 2001 at 17:56 |
kabster Founding Member |
Joined:
Posts: | July 2001
1,606 |
|
|
is 16 analog or digital ?
what are you useing for terestrial ?
You might just want to use a good 300 to 75 ohm. adaptor . Or a uhf amp with gain and or tilt , an antenna pre amp might help too.
|
|
| OP | Post 3 made on Tuesday January 1, 2002 at 20:52 |
automation-arts No Longer Registered |
|
|
Ok.........to clear things up...........
16 is not a channel.......
The tuner is probably picking up some sort of information on 16 since 15 is such a strong channel...
You know how you always get some extra channels when you search........
I wish to remove these channels and have only the ones that show up........
I receive all the channels perfectly fine.....Its just that I want only those in the lineup ....
Follow me??
Mat
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
