Post 1 made on Thursday February 19, 2015 at 09:28 |
OneTrak Lurking Member |
Joined: Posts: | February 2015 1 |
|
|
Hi, I'm trying to program activity based macros on my URC-200. Obviously to make these effective I need to program the discrete codes for inputs & power on/off. I'm trying to figure out the best way to make this happen. I've located the discrete hex codes on here and have them saved. Here is what I have access to: Pronto TSU2000, although I'm still trying to find where I hid the serial cable, Also have a UEI C4000 that is JP1 capable just would have to order a cable for it. Any thoughts on the easiest way to get these codes onto a button so I can learn it to the URC-200?
Thanks
|
|
Post 2 made on Thursday February 19, 2015 at 13:24 |
mdavej Active Member |
Joined: Posts: | December 2002 627 |
|
|
You can often enter the codes directly on a JP1 remote without having to use a cable. In which case the command can be sent without any programming whatsoever. If you post the pronto hex, we can tell you what buttons to press on your C4000 to send the commands. It would also be useful to know what devices and commands we're talking about.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.