Post 1 made on Sunday November 12, 2000 at 09:49 |
Brian McGee Historic Forum Post |
|
|
Hi, I've got an Onkyo T407 Tuner that I want to integrate into my whole-house stereo. It has a "R1" plug in the back for remote control, but I don't think it has a remote sensor on the unit itself. Does anyone know where I can get information about what the protocol is for the R1 port? I assume it would be possible to get something else to send out the correct codes, but I don't think I'm up to the challenge of reverse-engineering them. Especially since I don't have an Onkyo receiver to test with.
Any help would be greatly appreciated, thanks,
Brian McGee
|
|
OP | Post 2 made on Sunday November 12, 2000 at 18:47 |
jcmitch Historic Forum Post |
|
|
Take a look on www.Xantech.com and see if Onkyo is listed in the installation notes for the 794 or 797 interfaces. jcmitch
|
|
OP | Post 3 made on Sunday November 12, 2000 at 22:05 |
Brian McGee Historic Forum Post |
|
|
JC, That's awesome! They don't have my model listed, but it might work for me. I'll have to drop Xantech a line. Funnily enough, I'm integrating a Xantech 6 zone pre-amp. Thanks again for your help,
Brian
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.