Your Universal Remote Control Center
General Consumer Remotes Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Onkyo Remote - How To Program?
This thread has 1 response. Displaying all posts.
Post 1 made on Tuesday September 26, 2000 at 21:22
Historic Forum Post
I just bought an Onkyo 676 with RC-392M remote. Following the instructions to the letter, I can't get it to "learn". Specifically, I press (and hold) the "CD" mode button, then press "Enter", and release both keys. This is supposed to get it into "learn" mode to accept codes from my CD remote.

The "Send/Learn" light goes on when I press and hold "CD", goes off when I press "Enter", but does not come back on when I release the buttons.

What am I doing wrong?
OP | Post 2 made on Wednesday September 27, 2000 at 14:23
Historic Forum Post
Hey Fool,

It says "ENT" (on the bottom right of the controller), not "ENTER".

Later, press "AUDIO" and "ON". You won't believe the result!

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse