Post 1 made on Friday February 29, 2008 at 13:44 |
siggy_7 Lurking Member |
Joined: Posts: | February 2008 1 |
|
|
I have recently bought a RC9800i to replace my broken RU950. Whilst I can get it to control all of my Panasonic gear without difficulty, I cannot get it to control my PVR, a Humax 9200T. None of the pre-loaded Humax codes work. I have also tried the NEC codes, as recommended on the Humax forums, without success. The 9800 also does not recognise the Humax remote in learning mode, even when I replaced the batteries to give full signal strength. The frequency of the Humax signal is reported to be 38.1kHz, which should be within the learnable range I think. The 9200 is a popular PVR - have others experienced this problem and found a way to overcome it? I noticed a couple of earlier posts on this but no solution.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.