Post 1 made on Wednesday February 21, 2007 at 00:28 |
cschumm Long Time Member |
Joined: Posts: | February 2003 13 |
|
|
I am just getting started with ProntoProEdit NG but have done a lot of programming using ProntoEdit. I was able to do this in ProntoEdit but can't seem to figure it out in ProntoProEdit NG.
I have a small PNG graphic that I placed on my Home Page. It is a graphic of some tickets, and uses transparency supported by the PNG format. I want to assign actions to this graphic when it is touched, a series of Power On commands and Setup Commands followed by a jump.
When I right click on the graphic and select properties all I see is three tabs (Label, Appearance, and Dimensions) and there is no Actions tab.
Is there a way to assign actions to a graphic. I know this must be simple but I have been trying to figure it out for a couple of hours now and HELP isn't helping. HELP implies that if your right click and select properties the Actions tab will be there and it is not in this case.
Your advice is appreciated.
Chuck
|
|
Post 2 made on Wednesday February 21, 2007 at 00:56 |
Peter Dewildt Loyal Member |
Joined: Posts: | July 2001 6,307 |
|
|
Only buttons can have actions. You need to add a button to your page, then add the png to the button.
|
Peter Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired) Pronto 2xTSU9600, RFX9400 |
|
OP | Post 3 made on Wednesday February 21, 2007 at 01:08 |
cschumm Long Time Member |
Joined: Posts: | February 2003 13 |
|
|
Thanks Peter
I saw your post and figured it out thanks to your help. Kinda an indirect way of getting there but it works. I appreciate your pronpt answer.
Chuck
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.