I have a TSU6000. When attempting to learn volume up and volume down the learned command does not continuously move the volume, but moves the volume in small steps each time the volume control is pressed. Is there any way to get the volume control to move the volume up or down continuously by holding down the hard control button?

Thanks Much for any advice.

Wisdom is knowing the key to happiness is to avoid reinventing the wheel.

[email protected]

Post the IR code data that was learned for these commands. It is likely that these can be edited to achieve what you desire. The other solution is to see the FAQ about the press and hold under learning tips.

If you cannot see the code data then you need to enable 'developer' mode in the software.

There is a utility called ProntoUtil(s) (I think) that Daniel Tonks wrote/posted long ago that will do this. (search the files section)

Thanks Lyndell, that did it!