| Post 1 made on Tuesday February 2, 2010 at 10:52 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
Its been awhile since I have worked on a pronto, I have a client that is changing out a DVD player
If I go and relearn the IR commands to the existing buttons, will the IR commands in the macros work??? or do I need to edit all of those as well??
Thanks
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
| Post 2 made on Tuesday February 2, 2010 at 11:21 |
bomberjim Super Member |
Joined:
Posts: | September 2001
3,894 |
|
|
If you relearn over existing commands all your alias's and macro's will remain intact. If you start cutting and pasting or drag panel's around, you'll have to redo the links.
|
Jim L  |
|
| OP | Post 3 made on Tuesday February 2, 2010 at 12:58 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
Thanks Jim!!
I did add a few new buttons, But mainly concerned about Power and Play/Stop commands
Those all remained the same
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
