| Post 1 made on Monday April 19, 2004 at 10:37 |
Petri Ojala Lurking Member |
|
|
My ProntoPro (US TS6000, a few years old) has been unused for quite some time (lack of time to do a proper set of screens) and I finally decided spend the effort to put it in action.
The battery seems dead, which is I will try to replace but even if connected just to the power supply, the LCD display is very faint, barely readable. The backlight seems to be lit to some extend.
Any ideas what has happened? And how to fix it?
Petri
|
|
| Post 2 made on Monday April 19, 2004 at 12:07 |
raiders_fan94 Long Time Member |
Joined:
Posts: | September 2002
324 |
|
|
Petri,
Change changing the contrast wheel on the left side of the Pronto and see if that improves it.
|
Never underestimate the predictability of stupidity |
|
| Post 3 made on Wednesday April 21, 2004 at 04:46 |
Daniel Tonks Wrangler of Remotes |
Joined:
Posts: | October 1998
28,781 |
|
|
Also make sure the backlight is set to the brightest setting in the setup menu.
|
|
| OP | Post 4 made on Sunday April 25, 2004 at 20:47 |
Petri Ojala Lurking Member |
|
|
Thanks, I feel soooo stupid! It was the contrast wheel "problem".
Petri
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
