Post 1 made on Thursday April 8, 2004 at 08:26 |
Brett Wegner Long Time Member |
Joined: Posts: | April 2004 14 |
|
|
G,day. I asked the guys at KAONMEDIA for the Power off codes for my STB and they sent me this. I have tried entering these codes in protoedit as is but it but it wont accept them.
KAON IR POWER KEY CODE VALUE, CUSTOM : 0x2008 DATA : 0x0A
i am not even shure that this is what i need.
Any help would be apreciated.
|
|
Post 2 made on Thursday April 8, 2004 at 08:52 |
johnsfine IR Expert |
Joined: Posts: | September 2002 5,159 |
|
|
Do you have an original remote? I assume it wouldn't have the Power Off command, but if you can post Pronto Hex for ANY command for the same device, that will eliminate the ambiguity in "custom:0x2008, data:0x0A" so any of the experts here could then give you Pronto Hex for that command.
Otherwise it would need either additional information, or several attempts (there are a limited number of likely meanings for those custom and data values, and each could be tried).
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.