| Post 1 made on Friday March 19, 2004 at 11:38 |
Wendell Cotton Lurking Member |
|
|
My TSU2000 must have rebooted at some time when I was not around and is now locked on the Calibration screen. The latest firmware is installed and the same for ProntoEdit. I am able to communicate with the device, i.e. load and reload the firmware, reload the CCF file, etc., but nothing will reset the device. Yes, I have pressed the reset button MANY times.
Is there another way to reboot this device? I have left the batteries our for 2 days which has had no effect on the problem. Have tried different batteries as well. Done everything except tearing it apart to check connection or install a new screen - which I have.
Hoping that there is a "mystical" reboot that might solve the problem.
Help! HELP! :-)
|
|
| Post 2 made on Saturday March 20, 2004 at 01:02 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
When you reload the firmware what happens on the Pronto?
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
| Post 3 made on Sunday March 21, 2004 at 06:42 |
Daniel Tonks Wrangler of Remotes |
Joined:
Posts: | October 1998
28,780 |
|
|
Are you sure the problem isn't that you just aren't calibrating it right? You need to use a fine-point instrument like the tip of a pen or a stylus.
|
|
| OP | Post 4 made on Tuesday March 23, 2004 at 13:40 |
Wendell Cotton Lurking Member |
|
|
Hi,
It reboots to the calibration screen. That's all. The only screen I can get is the calibration screen.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
