Your Universal Remote Control Center
RemoteCentral.com
One For All & Radio Shack Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
kameleon 6-in-1 15-2133 and Sharp XL-UH242 mini system, problems
This thread has 3 replies. Displaying all posts.
Post 1 made on Wednesday September 10, 2014 at 21:10
mattress
Junior Member
Joined:
Posts:
September 2014
2
Hello! I am a complete newbie to remote controls.

I have a Sharp XL-UH242 mini system that the remote was lost to. Unfortunately, most of the controls for this system are on the remote only, and have no physical buttons on the actual system itself.

I dug out my old radioshack remote thinking I could program it to control the system, but none of the codes in the manual seem to work with it. Also, it's supposed to be upgradable over the phone some how, but seems the 1-800 number has been disconnected.

I have a Harmony One remote I was able to program to use most of the functions correctly, but don't want to use this remote for this device. My radioshack kameleon remote is supposed to be a "learning" remote, and I had the intention of teaching the correct buttons to this remote from the Harmony.

Hold "P" 3 seconds, 9-7-5, select device, then select key. But for some reason, this remote will not go into learning mode. I get what appears to be 1 long blink after dialing 9-7-5.

I found the JP1 lookup tool, but don't know what any of it means. I understand this is a JP1 remote, but the headers need to be soldered into the board, and I would have to create a cable for it, if this is needed.

I also have a spare comcast red button remote I could donate to this project if needed.

Thanks for any tips
Post 2 made on Thursday September 11, 2014 at 01:26
edmund
Elite Member
Joined:
Posts:
April 2002
13,469
Try:

1. device key
2. press and hold P for two blinks. release
3. enter 9 7 5
4. pick a key
5. teach

Once finished teaching, press and hold P to lock in commands.

If you're attempting to teach to the power key, and that's when you get the error sound, reason is you can't teach to the power key. Use other keys.

Last edited by edmund on September 11, 2014 01:33.
Post 3 made on Thursday September 11, 2014 at 02:27
3FG
Select Member
Joined:
Posts:
August 2009
1,857
Another possible cause is the memory may already be full.  If you think that may be the case, do a 980 reset to clear out the learning memory of your Kameleon.  Or, try Setup code Audio (CD) 0186.  It may control the system.

 
OP | Post 4 made on Thursday September 11, 2014 at 13:39
mattress
Junior Member
Joined:
Posts:
September 2014
2
I had to reset the remote. 9-8-7 I think it was? Now it learns fine. Audio 0186 makes the power on/off work, but nothing else. I was able to teach the rest of the buttons from a harmony remote.


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse