Post 1 made on Thursday September 22, 2005 at 00:27 |
deanerh Lurking Member |
Joined: Posts: | September 2005 2 |
|
|
In an earlier thread, Edmund advised that the only way to get a command programmed to go directly to Video 7 input was through JP1. I've used the JP1 interface and programs to do a variety of things with my remote, but I don't understand the process that I would use to do this. Please explain.
|
|
Post 2 made on Thursday September 22, 2005 at 00:40 |
edmund Elite Member |
Joined: Posts: | April 2002 13,841 |
|
|
Jp1 questions are best asked in the JP1 Forums. The protocol that Video 7 is found in doesn't equate to a known setup code, thats way you need jp1.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.