| Post 1 made on Thursday August 4, 2005 at 10:48 |
pawsey Lurking Member |
Joined:
Posts: | August 2005
2 |
|
|
Hi - I'm trying to input new codes into my 8060 over the internet. I seem to be having problems entering the correct sequence of keys for the unti to enter it's upgrade mode.
In accordance with the One4all website instructions I press:
Any device key (eg TV).
Press the "magic" key until rabbit appears.
Finally press the power key, at which point the IR display should cycle 3 times in reverse.
In my case this doesn't happen, IR display just blinks once.
Can someone confirm that I am entering the correct sequence of keys?
Many thanks.
|
|
| OP | Post 2 made on Thursday August 4, 2005 at 18:13 |
pawsey Lurking Member |
Joined:
Posts: | August 2005
2 |
|
|
OK. Managed to sort this one out - unit needed a master reset, Everything OK now.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
