|Post 1 made on Thursday February 24, 2005 at 11:26|
Has anyone removed the motion sensor from the Kameleons? If so, is it difficult? It sounds like a good remote if it didn't eat batteries.
|Post 2 made on Thursday February 24, 2005 at 13:04|
|OP | Post 3 made on Thursday February 24, 2005 at 16:58|
Got it! It was simple to do on the Radio Shack 6 in 1 (15-2133). Remove the screw on the battery door and remove the door. If there are batteries in the remote, remove them. Slice the black plastic area that surrounds the battery door by pulling it off the end of the remote. Remove the four screws on the silver back and slide the back off the same way. The board is now exposed. On my unit, the switch is marked SW-1. It's on the right side of the battery holder in the middle of the board. There is a wire going into one end of the switch. Carefully clip the wire and gently pull up the switch so the wires don't touch. Close up the unit and you're ready to program the remote.
|Post 4 made on Wednesday March 23, 2005 at 07:47|
after doing this I cannot use the direct Learning function anymore.
I do this:
1. press magic until rabbit pops up
2. press 9 7 5 (indicator flashes twice)
3. press TV
and now it fails, the remote (urc8060) just returns to the tv remote function. this happends no matter what function I choose in step 3.
I've tried resetting the remote with code 9 8 1
but this does not help me at all. I can program the remote, but I cannot use direct learning.
|Post 5 made on Wednesday March 23, 2005 at 11:29 |Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.