Post 1 made on Thursday October 28, 2004 at 14:28 |
bankcello Founding Member |
Joined: Posts: | December 2001 14 |
|
|
I just added a DVD (Cyberhome 300) to my 8910. However, I am unable to add functions using the keymover and advanced codes. I get a memory full message.
Is it possible, without clearing the entire remote. to free up some memory that is devoted to things I no longer want?
Thanks.
|
|
Post 2 made on Thursday October 28, 2004 at 14:45 |
edmund Elite Member |
Joined: Posts: | April 2002 13,839 |
|
|
You can clear a single key or a one whole device of EFC's, without effecting the other devices.
To clear a device, say Tv:
1. press and hold SET 2. scroll down until KEYMOVER 3. press SELECT 4. press device (TV) 5. press device (TV) again 6. press SELECT
To clear a key:
1. press and hold SET 2. scroll down to KEYMOVER 3. press SELECT 4. press device (TV) 5. press key 6. press device again 7. press key again too. 8. press SELECT
|
|
Post 3 made on Thursday October 28, 2004 at 16:47 |
The Robman Loyal Member |
Joined: Posts: | August 2001 6,218 |
|
|
If by "added" you mean you downloaded an upgrade over the phone or added one using JP1, you can do an OPS RESET, which will clear all your keymoves, macros and learned signals, but will leave your upgrades intact.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.