Post 1 made on Monday February 21, 2000 at 11:54 |
Bill Margol Historic Forum Post |
|
|
Ok, so I finally decided between the 15-1994 and the 15-1995. I decided to keep the 15-1994 and so far it works great. So here's the next stupid question...no where in the instructions or in the FAQ that is frequently mentioned around here does it say HOW to program a Macro into one of the learning keys. Can anyone help me with the programming sequence of how to do it?
Thanks!
Bill
|
|
OP | Post 2 made on Monday February 21, 2000 at 15:13 |
David B. Historic Forum Post |
|
|
This works for a Cinema remote. Try it on your RS.
Press and hold SETUP until you get two blinks. Enter 995. Press the key L you want the macro on. Press up to 15 buttons in the order that you want them to be executed. Remember every button even the device and setup ones count as one of the 15.
When done, press and HOLD setup until you get two blinks.
Substitute whatever key works for SETUP on your RS remote in the above sequence.
Good luck. Remember, the macro will use the key in EVERY device.
Dave
|
|
OP | Post 3 made on Monday February 21, 2000 at 22:54 |
Gerard J. Pinzone Historic Forum Post |
|
|
The above info is correct, but allow me to make a few clarifications. The SETUP key is the green "P" button. There are no "L" keys, but there are 4 "smart" buttons. [Link: ampersand.hypermart.net]
|
|
OP | Post 4 made on Monday February 21, 2000 at 22:56 |
Greg Mowad Historic Forum Post |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.