Post 1 made on Monday April 14, 2003 at 10:50 |
Melvin Founding Member |
Joined: Posts: | January 2002 13 |
|
|
I have 2 ExpressVu 5100's in adjacent rooms. I have 15-1994's for both. I need to change remote addresses. Do codes exist for remote address 2? I tried learning all the buttons but not enough memory exists for them all. Thanx.
|
|
Post 2 made on Monday April 14, 2003 at 11:48 |
johnsfine IR Expert |
Joined: Posts: | September 2002 5,159 |
|
|
What setup code do you use for the first remote address?
With that setup code, I could check whether there exists some other setup code is similar enough, but with the right difference, that it might be an alternate address of the same device.
Most likely, there isn't. In that case, creating one would be very easy with a Jp1 cable, but without a JP1 cable you're stuck with learning however many fit.
|
|
Post 3 made on Monday April 14, 2003 at 12:08 |
tabish121 Long Time Member |
Joined: Posts: | February 2003 11 |
|
|
Some time ago I need to use addresses 1-4 with my setup, and I ended up creating a device upgrade with Keymap for each of the codes.
The Device code for address 1 is 0775.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.