Looking for discrete codes for:

Mitsubishi rear-proj tv inputs (a couple are listed, need component 1 & 2 in particular, a full list would be nice if you got it!);

Yamaha receiver DSP mode cycling, to cycle thru all of the available audio modes. (Two hard buttons for this --up & down-- are present on the receiver.)

Many thx in advance!!!

Thes are all for TV_0150: Protocol=(Mitsubishi):Device=71. FYI, OBC's are after the device numbr but you should only need the EFC's.

"Input-1" (Mitsubishi):71:98 EFC:223
"Input-2" (Mitsubishi):71:106 EFC:95
"Input-3" (Mitsubishi):71:114 EFC:159
"Input-4" (Mitsubishi):71:122 EFC:31
"Cmpnt-1" (Mitsubishi):71:105 EFC:89
"Cmpnt-2" (Mitsubishi):71:97 EFC:217
"VGA" (Mitsubishi):71:49 EFC:137
"DTV-1" (Mitsubishi):71:121 EFC:25 "this may be a toggle between DTV 1,2,3,and 4
"On" (Mitsubishi):71:66 EFC:255
"Off" (Mitsubishi):71:74 EFC:127

Yamaha publishes some of their command sets.

[Link: yamaha.com]

Even if your device isn't listed the commands will probably work. If there is such a command one, of us will help you translate them into a setup code and EFC if they exist.

-Jon

Thx! I have a Cinema 7 now, will be using it to teach my MX500 that's arriving today. Can't wait!

Yamaha RX-V596 using Cinema 7+:

Device: AMP 0176

Mode- : EFC:233
Mode+ : EFC:229

Ron

I am using device code 150 (forgot to mention it before). Alas, these input select codes don't work for my WS65819. $^( Any ideas? [Or am I wrong in thinking that the codes 089 and 217 are the ones to enter in the OFA under the TV device?]


Fortunately, I decided I don't need the Yamaha mode scan code. With my new MX500, I decided to program a page of all the audio modes onto the cable and DVD devices. Works great!! Hoping to solve the Mitsu input codes so I can do up some macros now. (I have a Cinema7 to train the MX500.)

Thx for the responses!!!