Your Universal Remote Control Center
One For All & Radio Shack Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Help setting up 15-2116 for yamaha RX-V430 reciever
This thread has 2 replies. Displaying all posts.
Post 1 made on Saturday February 15, 2003 at 11:22
Evil Penguin
Long Time Member
November 2002
Hi all

I have been trying all day to get the RS 15-2116 remote to control some of my functions on the reciever. I have tried codes like 0176 and a few others and it has the ability to turn on the reciever but I can't get it to change to the dvd or cable. Or some of the other functions. I tried using advanced codes but they didn't seem to work. Any help would be greatly appriciated! I just want the remote to work like the remote I got for my RX-V430 yamaha reciever.


Post 2 made on Tuesday February 18, 2003 at 06:49
Lurking Member
February 2003
I just got my 8811 remote today, and have run into some of the same things as you, so hopefully this might help, even though it's a different remote than yours.

With my RX-V620 receiver and the 8811 remote, the 0176 setup code controls most things. Pressing 1 alone switches to Tuner, 2 switches to VCR 1, etc. All the numbers switched to something, except 5 and 6, which did nothing. These numbers don't correspond with the original remote, which I found interesting. That is, Input-1 on the original remote switches to CD mode, Input-2 to Tuner, instead of Tuner and VCR1 on the new remote. Also, I found that DVD and TV/CBL were missing as you did.

Going to [Link:], I found that extended code 100 was for Cable. I used the method at [Link:][1.13] for entering Extended codes, and put the Cable function on key 5.

For DVD, I found that the 122 code listed did not work for me. By chance, the very first code that I happened to try for something else switched to DVD. So, I put extended code 177 on key 6 for DVD.
Post 3 made on Tuesday February 18, 2003 at 22:48
Long Time Member
November 2002
I had similar problem initially as well. I have the Rxv1300 receiver and 8811 remote.

I emailed OneforAll and they were nice enough to send me a list (took a couple of weeks) of all the advanced codes for the 1300. Using this I created a new device in JP1. CBL/SAT is now assigned to my 1 key. The 'VCR' buttons (play, fwd, rwd, etc...) change the DSP modes (only programmed the ones I use).

You could try code 1176 as well. In the 1300 it controls the zone2 settings.

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse