Post 1 made on Sunday February 2, 2003 at 00:36 |
Fer-rust-trated Lurking Member |
Joined: Posts: | February 2003 1 |
|
|
For some strange reason, I cant reassing the record key using advance codes for my URC-6800 --- and yet, my other URC-6800 (my spare) I can!! I seem to remeber running across this bullcrap problem before, it had something to do with the fact that one had a learned button in memory and the other didnt, OR one have volumn lock enabled the other didnt......ARRRRGHHHHHHHHHH!!!!!!!! I'm at wits end to remember what the problem was......TRUST me....when I ever find out again...I'll write it down in STONE!!!
|
|
Post 2 made on Sunday February 2, 2003 at 08:37 |
johnsfine IR Expert |
Joined: Posts: | September 2002 5,159 |
|
|
If you have a key move and learned signal on the same key in the same device mode, the learned signal wins and the key move is ignored.
You should try the 976 command for deleting the learned signal and see if you then can do the Key move.
You should look at Rob's improved versions of the manuals at
The 6800 is a 7800 with one button missing, so usethe 7800 manual.
The section on the 976 command is
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.