| Post 1 made on Thursday February 3, 2000 at 12:44 |
Hiya folks,
Is there a master reset code that will set the Cinema-7 back to the state it was in when I took it out of the package!?
Now that I'm done playing around and learning the capabilities, I want to start over and set it up right.
Thanks!
Gary
|
|
| OP | Post 2 made on Thursday February 3, 2000 at 15:58 |
David B. Historic Forum Post |
|
|
Press SETUP and hold it until you see two blinks.
Enter 981.
Be forewarned, you will have to enter everything again, even device codes.
If you just want to reset all the additional programming you've done, but leave the devices set up, use 980 instead.
Dave
|
|
| OP | Post 3 made on Friday February 4, 2000 at 13:08 |
Cool Dave, thanks for the info!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
