Post 1 made on Saturday November 17, 2001 at 11:17 |
Mike Hallesy Founding Member |
Joined: Posts: | November 2001 5 |
|
|
Hi All, I have a OFA UPC-5550 ( I think it's a OneForAll 6) , I've downloaded the upgrade for Pioneer Code 468 and set the CD function for this code. Problem is the "Stop" button is inoperative except that it seems to produce an "FF" response on the CD Changer or nothing at all. I find OFA support is pretty good but their site is slow and difficult to negotiate , can anyone point me in the right direction towards solving this problem ? , I'm relatively new to this. Thanks Mike
|
|
Post 2 made on Saturday November 17, 2001 at 13:55 |
The Robman Loyal Member |
Joined: Posts: | August 2001 6,218 |
|
|
Try programming advanced code 118 to the STOP button. If you don't know what advanced codes are or how to program them, check out the info on my site. You can use the instructions in the Producer 8 manual as a guide for the 5550. Rob. http://www.hifi-remote.com
|
|
|
OP | Post 3 made on Saturday November 17, 2001 at 14:39 |
Mike Hallesy Founding Member |
Joined: Posts: | November 2001 5 |
|
|
Thanks for the reply Rob, tried setting code 118 , both by assigning to "Stop " key , also by testing CD changer response to code by keying: Device , Setup (Magic on URC-5550 ?) ,118 In both cases the result was LED display on changer being zeroised but the CD did not stop playing ! Mike
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.