Here's one for the Macro experts........I haven't had any luck figuring out how to include the 'power up'of my receiver in a macro that turns all of my components on. Here is my problem, I need to 'hold down' my input select key for 2 seconds for my receiver to turn on but when I program this into my 15-1994, I can't fiqure out how to program that 'hold down' delay. When programming the macro I get all of my components to come on excluding the receiver. I welcome any and all suggestions..........Thanks TJ

First trick is to see if there is an advanced code for this. What kind of receiver is it? And what device code do you have it set to?
Take a look at the advanced codes at www.hifi-remote.com

Jim

Jim........Thanks for the reply. My receiver is a Philips FR968 (code 0189)... btw this code only turns my unit off --I had to 'learn' all commands from original remote because I could not find the advanced codes, for 0189, listed @ above website.?. Would there be any other way of obtaining these advanced codes?

Thanks............TJ

Rat Shack 1994, as my wife says:
"gee...amother nerd toy..."
after surfin for remotes, I stumbled across this forum, so far so good.
Anyone know how to set up your receiver for this puppy?
and if someone could clue me in please? as in all
Rat Shack's products, the instructions are written for
clairvoyents.... and how does the keys tranpose over?
Panasonic/Technics receiver # SC-HT280 same as Technics
# SA-DX1040 Thanks gang!

[Link: hifi-remote.com]
read it