Post 1 made on Saturday February 24, 2001 at 05:40 |
JackMultiple994 Historic Forum Post |
|
|
I have an old C7 that I dug out the other day to try and program something on. All the digit buttons work (the red LED lights up) when I press them in normal use... but when I go into "setting up a device mode" some of the digit keys don't function. Specifically the "1" digit and I believe the "7" digit. In other words, if I'm trying to setup a device with a lookup code of 0101, and I press/hold SETUP until it flashes twice, I can then press the "0" digit and the red LED flashes, but when I press "1" the red LED doesn't flash. I can press other buttons (in setup mode) and the red LEDs flash, and then I get a double-flash at the end to know it worked. But a couple digits just will not work in Setup mode, but they DO work in other modes.
I tried the 980 reset and that didn't help. Any other advice? Is there a different master reset code?
Thanx. Jack
|
|
OP | Post 2 made on Saturday February 24, 2001 at 12:07 |
The Robman Historic Forum Post |
|
|
The master reset command is 981
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.