| Post 1 made on Wednesday January 10, 2001 at 01:33 |
Steve Enns Historic Forum Post |
|
|
How do I put a advanced code into a macro on a 15-1994?
Do I have to program a button with the advanced code,
and then put the button in the macro, or can I put
the advanced code directly in the macro?
Thanks!
Steve
|
|
| OP | Post 2 made on Wednesday January 10, 2001 at 09:49 |
The Robman Historic Forum Post |
|
|
|
| OP | Post 3 made on Wednesday January 10, 2001 at 13:03 |
Steve Enns Historic Forum Post |
|
|
Ok, so HOW do I use an advanced code in a macro?
Do I just use "" followed by the 3 digit code
where I would normally have a keypress?
Thanks,
Steve
|
|
| OP | Post 4 made on Wednesday January 10, 2001 at 13:18 |
The Robman Historic Forum Post |
|
|
The best way is to just program a button with an advanced code and then use it in the macro, but you could also program SETUP (green P) followed by the three digit number if you really want to, but I would expect that this would cause a greater delay in your device responding because it has to wait for the remote to do 4 key presses.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
