Post 1 made on Wednesday January 3, 2001 at 14:38 |
Sal Bugliarisi Historic Forum Post |
|
|
Is this possible:
1. Point my Yamaha remote at my Cinema 6 (6800L) 2. "Learn" a few of the Yamaha commands into my Cinema 6 1L/2L/3L/4L buttons 3. Copy the 1L/2L/3L/4L buttons to one of the Cinema 6 arrow buttons
Or better yet, can I send a command from my Yamaha remote and learn it directly into any button on my Cinema 6 (6800L)?
I've read all the FAQ's but I can't find a direct answer to my question.
Thanks, Sal
|
|
OP | Post 2 made on Wednesday January 3, 2001 at 15:16 |
Jim Cruicshank Historic Forum Post |
|
|
My Cinema 7 will learn on any button not just the 4 learning buttons. Give it a try on your Cinema 6, it is the eaxact same procedure as if it were a learning button. If it works - it works!
Jim
|
|
OP | Post 3 made on Wednesday January 3, 2001 at 22:46 |
David B. Historic Forum Post |
|
|
Jim is right. There's no need to learn, then move, since you can learn directly to the key you want the command on.
No, it doesn't say that in the manual. There is TONS of info about these great remotes not covered or incorrect in the manual.
Dave
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.